Very frequently, you would like only selected events to trigger an action, send a message or store an event story. Starting with software version V1.9.4 you can use Event Selection to control Event Stories, Actions and Messages.
In the E-Mail Profiles dialog, create a profile with an e-mail address to which to send the message.
In the General Event Settings dialog, enable the Arming option.
|In order to store images and to perform actions and messages, arming has to be enabled.
Set the number of pre- and post-alarm images for the Event Story.
In the Event Settings dialog, activate the Video Motion Window (VM), the Passive Infrared Detector (PI) and the Periodic Event (PE) options.
For the Periodic Event option, select the Seconds interval unit and enter 30 as value for the interval.
In the Messaging dialog, define the events that should trigger a message. In the Event Selection section, activate the VM - Video Motion and PI - PIR Detector options.
|Use [Ctrl]-Click to select more than one entry.
In the E-Mail Action (EM) section, select the name of the e-mail profile you created before.
Select the event story entry to set the proper attachment type.
Click on the Set button to activate your settings and to save them until the next reboot of the camera.
Click on the Close button to close the dialog. While closing the dialog, the system checks the entire configuration for changes. If changes are detected, you will be asked if you would like to store the entire configuration permanently.